Clearone MAX IP Response Point User Manual download pdf (Page 6)

2 Technical Services: 800-283-5936

and set up your phone using the Configure Phone Wizard in the Response Point Administrator’s Guide.

THE LCD DISPLAY

The LCD display acts as a legend for the various modes, codes and functions of the device. Each function is cov-

ered in this manual or the Administrator’s Guide.

USING THE PHONE

Make a Call

Press the 1. key to activate the phone. You will hear a chime or spoken prompt.

Speaking clearly, say the name of the person in your Contact List you wish to call. 2.

Press the 1. key to activate the phone. You will hear a dial tone.

Dial the number as you would on a standard phone. The number appears on the LCD screen.2.

You can also pre-dial the number while in Standby mode and press the key to connect the call.

To add a pause to the number you are pre-dialing, press and hold the pound (#) key.

Answer a Call

When there is an incoming call, the following will occur:•

The phone will ring (unless the ringer is turned off).1.

The phone’s 3 LEDs will flash.2.

The phone icon on the LCD screen will flash.3.

To answer • press the key.

End a Call

Press the key.

Turn the Ringer On/Off

Press and hold the “*” key until the Ringer Off icon appears on the LCD display.

Adjust Ringer Volume

While the phone is ringing, press 1. or .

While the phone is inactive, press 2. or . The ringer melody will play once at the new level.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Clearone MAX IP Response Point User Manual Page 6