ClearOne V-There 2000 Setup Guide download pdf (Page 25)

Chapter 4:

COLLABORATE Room: Installation and Setup Guide 25

System Configuration

IN THIS CHAPTER

This chapter describes how to configure the system and includes the following sections:



Starting the System



Monitor Configurations



Display Settings



Network

STARTING THE SYSTEM

Once the system is properly wired, connect it to the electricity and power it up using the

power switch on the front. When system fully loads, you will see the view from the camera

on the entire screen.

The COLLABORATE Room system is capable of using one or two displays. According to

the devices you physically connected to the system, configure the appropriate settings

using the system configuration options.

In order to access the configuration screens, press the Menu/OK button on the remote

control. A menu will open with various options. Select the Settings option and press the

Menu/OK button on the remote control, or use the right arrow to expand this menu option.

MONITOR CONFIGURATIONS

The COLLABORATE Room display configuration ranges from single monitor to dual

monitor. When using a single monitor, both the local video and remote video are displayed

on the same display, whereas when using dual displays, each video stream is displayed on

a separate display.

The video output signal can be connected using various output interfaces:



DVI – The DVI (Digital Visual Interface) interface is common in LCD and flat panel

displays.



HDMI – The HDMI (High-Definition Multimedia Interface) interface is common in LCD

and flat panel.

When connecting your system, please follow the attached quick reference sheet for using

the connector which is appropriate to your system. Once the displays are connected, use

the system user interface to configure the display settings.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

No comments

ClearOne V-There 2000 Setup Guide Page 25