ClearOne AP10 Specifications download pdf (Page 14)

Technical or Setup Assistance

Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • http://www.gentner.com

Page 10 Audio Perfect

10 Installation and Operations Manual

Calibration

Continued

Operation

Receive Level Adjustment

Someone in the distant location should speak into the microphone at a normal

distance, in a normal voice; the local room should maintain silence. Adjust the

AP800 input that is connected to the AP10 RECEIVE OUTPUT to 0dB. The

AP10 RECEIVE LED [2] should be solid green while the person is speaking and

extinguish when the person stops.

Calibration is now complete.

Easy-to-access and read front-panel controls make operation of the AP10 simple.

Figure 12a (below) shows each front panel LED and button by number.

Answering a Call

An incoming call will ring on the telephone set connected to the AP10 and flash

the ON LED. Answer the call by pressing the ON button [5] on either the front

panel or from your remote control. This will route the call through the AP10 to

the AP800. The green ON LED [3] will light. The red OFF LED [4] will dim.

Upon connection, the AP10 automatically (method of adaptation depends on the

position of dip switch 1) adjusts to the line conditions.

Answer the call by picking up the telephone handset and talking to your party

over the telephone.

AUTO-ANSWER NOTE:

If auto-answer is enabled (dip switch 4), the AP10 will answer after the first complete

ring.

Making a Call

Call the party normally, using your handset. After the other party has answered,

route the call through the AP10 by pressing the ON button [5]. The ON LED [3]

will light and the AP10 will take control of the call, disabling the telephone set.

You may now safely hang up the handset without disconnecting your call. When

the conversation is complete, press the OFF button [6] to disconnect the call.

If using RS232 touch tone, it is not necessary to hit the ON button [5]. When

using the DIAL serial port command, the AP10 automatically engages the hybrid.

See Appendix B: Touch-Tone Dialing (Page 19).

Disconnecting a Call

If the call is routed through the AP10 (the ON LED [3] will glow), press the OFF

button [6] (OFF LED [4] will glow, ON LED [3] will extinguish).

Figure 12a. AP10 front-panel controls

2 4

Transmit

Receive

Off

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Comments to this Manuals

No comments

ClearOne AP10 Specifications Page 14

Comments to this Manuals

Related products and manuals for Networking ClearOne AP10