ClearOne AP10 Specifications download pdf (Page 6)

Technical or Setup Assistance

Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • http://www.gentner.com

Page 2 Audio Perfect

10 Installation and Operations Manual

Product

Description

Easy to install, easy to operate

DTMF dialing capability

Simultaneous two-wire/four-wire operation within an Audio Perfect™ system

G-Link network interconnection with up to eight AP800s and 16 AP10s.

9.6kHz sampling rate allows continual adaptation to telephone-line conditions

Full-time Telco echo cancellation with 26 millisecond tail time

Conference up to 16 callers (with 16 AP10s) within an Audio Perfect™ system

Digital anti-alias filter minimize hum and Central Office switching noise

Remote ON/OFF control via serial commands or rear-panel connection

Digital send filter/limiter for telephone line-noise reduction

Compatible with any analog telephone system

No outside RF interference will affect performance

Front-Panel Controls

The AP10 front-panel controls (See Figure 2, below) perform the following

functions:

1. Transmit LED. This bicolor LED indicates the audio levels being transmitted

from the room to the telephone line.

2. Receive LED. This bicolor LED indicates the audio level the room is receiving

from the telephone line.

3. On LED. This bicolor LED indicates the hybrid’s ON state. The LED will

illuminate green when the hybrid is in the ON state.

4. Off LED. This bicolor LED indicates the hybrid’s OFF state. The LED will

illuminate red when the hybrid is in the OFF state.

5. On. The ON switch (momentary), connects the hybrid to the telephone line

(dependent upon dip switch settings), and automatically adapts the hybrid to the

line. Pressing and holding the ON button for more than a half-second while the

hybrid is active will readapt the hybrid.

6. Off. The OFF switch (momentary), disconnects the hybrid from the telephone

line and mutes all audio.

Features and

Benefits

Figure 2. AP10 front-panel controls

2 4

Transmit

Receive

Off

1 2 3 4 5 6 7 8 9 10 11 ... 29 30

No comments

ClearOne AP10 Specifications Page 6