ClearOne AP10 Specifications download pdf (Page 11)

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

The AP10 is designed for easy installation and set-up. All connections are made

through rear-panel connectors. This section provides instructions on installing the

units in the rack and making initial connections, creating a G-Link network, and

assigning device ID numbers.

The diagram below illustrates the typical connections that are made when

adding an AP10 to an AP800.

CHAPTER 2: Installation

AP10

AP800

Telephone set

(optional)

Transmit

Input

Receive

Output

Microphones

Inputs

Touch panel

controller

G-Link connection

Line

Figure 2.1. System diagram

Hardware Setup

Connect the unit

Refer to the rear-panel drawing in Figure 2.2 on the following page. Each connector

is numbered for easy identification.

1. Place the unit in the rack and attach it securely. AP10 models are designed

for installation in a standard 19-inch equipment rack.

2. Connect your telephone line from the wall jack to the RJ-11C Line jack [F].

3. Plug your telephone set into the RJ-11C Set jack [G].

4. If you are using a custom controller for control and hybrid status, plug it

into the DB-25 Remote connector [C].

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

No comments

ClearOne AP10 Specifications Page 11