ClearOne AP10 Specifications download pdf (Page 7)

Introduction ~ Controls and Connections

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

ClearOne is not responsible

for product damage

incurred during shipment.

You must make claims directly with

the carrier. Inspect your shipment

carefully for obvious signs of

damage. If the shipment appears to

be damaged, retain the original

boxes and packing material for

inspection by the carrier. Contact

your carrier immediately.

Unpacking

Ensure that the following items were received with your shipment:

Controls and Connections

Front view

DIP switches.

Operational features can be enabled or disabled via DIP

switches behind this panel. These features include auto-answer, auto-disconnect,

momentary or latching mode, device identification, caller AGC, caller boost, and

noise burst adapt/self adapt.

B. Transmit LED. This bicolor LED indicates the audio levels being transmitted

from the room to the telephone line.

C. Receive LED. This bicolor LED indicates the audio level the room is

receiving from the telephone line.

D. On. The On button connects the AP10 to the telephone line (dependent upon

DIP switch settings) and automatically adapts the hybrid to the line. The

LED will illuminate green when the hybrid is in the On state.

E. Off. The Off button disconnects the hybrid from the telephone line and mutes

all audio. The LED indicates the hybrid’s Off state. The LED will illuminate

red when the hybrid is in the Off state.

Figure 1.2. AP10 front panel controls

Figure 1.1. AP10 unpacking diagram

Pressing and holding the

On button for more than a

half-second while the

hybrid is active will readapt the

hybrid.

✍

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

No comments

ClearOne AP10 Specifications Page 7